Blog

Analysis of wiring requirements of Electrical Ready Board

Publish Time: Author: Site Editor Visit: 423

The distribution box is to provide low voltage for the circuit system and protect and convert the circuit at the end of the system. This is the distribution box. Next, the manufacturer of the distribution box will take you to know the wiring requirements of the Electrical Ready Board.

 

If you install a Electrical Ready Board, you need to buy an incoming line, which is about four square meters. Connect it to the main switch of the household through the live wire in the leakage switch, and connect it to the switch of each room through the live wire. Because the neutral line is public, it is OK to separate it to each room. When connecting the Electrical Ready Board, you should see the design of the wiring diagram of the Electrical Ready Board clearly, and don't confuse the neutral line and the live line. Once the two are connected incorrectly, there will be no power supply and cause misunderstanding to people. In fact, whether they are connected correctly or inversely, because of the role of leakage switching, the neutral line and the live line will act, because many neutral lines are connected together in the leakage switch, so after opening the switch, There is no neutral line but live line disconnected, so attention should be paid to the problem of live line and wrong connection of neutral line. As for how to distinguish the two, don't make a mistake, you can look at the leakage switch.

 

Before installing the Electrical Ready Board, you must buy all the equipment involved, then measure the rated current and working voltage of the household circuit, configure a similar distribution box according to the power supply of the household circuit, and then design a wiring diagram of the Electrical Ready Board, and carry out construction and installation through the wiring diagram of the Electrical Ready Board.

 

Next Factors affecting the normal operation of Ready Board With Wiring and Bulkhead